One of the most important elements of the washing machine is the pump, which pumps water inside the unit and helps to remove it from the drum after washing or rinsing. Failure of this unit does not allow washing in the desired mode, it is necessary to repair or replace the part. How to do this, it is proposed to find out more information on mannyappliances.com.
Rules
The operation of the pump in the washing machine can be disrupted due to a clogged filter, when water simply does not pass, or a faulty electrical part, when the device needs to be replaced. How to check these parameters is proposed to find out more on Manny Appliances.
When checking and replacing, it is necessary to observe the following rules:
- Determine the cause that caused such a malfunction.
- Inspect the electrical circuits for their integrity, the absence of soot or oxidation on the contacts.
- To ring the circuit, a multimeter is used, with which the resistance and voltage are checked.
- The machine must be disconnected from the network by removing the power cord plug from the outlet.
- Next, the device is pulled out to the center of the room, the water is drained and disassembly begins. The process depends on the model of the machine, often it is necessary to remove the front and back panels.
- To check with a multimeter, you need to start the machine, for which it is disassembled and connected to the network. The terminals of the device are connected to the pump contacts and the device is started.
- In this case, the drum can move, the motor of the machine can turn on, so it is necessary to put it in a vertical position.
- It is necessary to ensure that the contacts do not short-circuit, so that no electric shock occurs.
All work with electricity is carried out only on a completely dry floor to avoid negative consequences.
After determining the condition of the pump, a decision is made on repair or replacement. It is suggested to familiarize yourself in more detail on MannyAppliances with the entire procedure for checking and replacing.
Tips
A specialist should check the pump and study all the reasons that could lead to its breakdown. In addition to knowledge of disassembling the machine, skills in electrical engineering, strict adherence to safety standards are required to avoid short circuits or electric shocks.
When replacing the pump, you must use a similar device according to the article number, suitable for a specific model of the washing machine. This figure will be the same for both the original and aftermarket parts. You need to find yours in the list of suitable machines before purchasing and installing the pump.