The upper gap between the ceiling and the wallpaper is covered with a fillet – a ceiling plinth. The fillet is made of polyurethane or foam. Material color is usually white.
Looking for a good site where you can choose a good manipulator unic? You can find it at a reasonable price on this website .
Plinth is light and inexpensive. Different width of the strips will allow you to choose the appropriate dimensions to mask various docking defects.
For a quality connection of the planks, you will need to cut the plinth at an angle of 45 °, for this it is better to use a miter box. The material is quite malleable and can be easily cut with a sharp mounting knife. Docking corners are recommended to be reproduced before gluing the planks. Prepared materials are laid out on the floor.
The plinth is glued alternately, after setting the first plank, the second is attached to it. The glue is applied in a thin strip on two surfaces of the fillet, one side is fixed to the ceiling, the other to the wall. To increase the adhesion of the adhesive composition, it is necessary to withstand the applied adhesive a little.
The plinth is gently pressed with clean hands. White material is easily soiled, metal tools leave dents and scratches on its surface. Excess glue is removed with a dry cloth. If the walls or ceiling are uneven, the plank can peel off; to fix it in the desired position, a masking tape is used, which can then be easily peeled off from the wallpaper. Docking slots are sealed with silicone sealant.